01
Procedure chosen for the ECU
We assess the available access method and prerequisites first.
Equipment · EQP_01
Magic Motorsport Flex
Magic FLEX for programming supported control units and working with calibrations after compatibility checks.
Chip tuning · Calibration · studio visualization of the tool
EQP_01 · STATUS: IN SERVICE
What this tool is
FLEX reads and writes software on supported engine and transmission control units. The connection method (OBD, Bench or Boot) depends on the unit, protection and supported protocols.
Before programming, we identify the ECU and assess the method and suitable original file. Full readout and a return to factory software are not available in every case; feasibility is checked for each vehicle.
What it can do
OBD, Bench or Boot access for supported ECU/TCU families
ECU hardware/software identification and protocol assessment
Read and write supported software areas
Agreed calibration work and checks after programming
How it helps you
02
Vehicle-specific calibration
The ECU, engine condition and software version guide the work.
03
Factory software return where supported
Restoration requires an appropriate original file and a supported writing procedure.
Other equipment
Ready to start the job?
Describe the problem in the contact form — we reply within a day.